« Electronic Circuits Homepage

Stepper: Motors

Photo: Encoded Stepper Motor Controller Encoded Stepper Motor Controller
This kit uses a Grey switch aka bit switch, to single step a unipolar stepper motor in either direction. Uses a
Photo: Bi-Polar Stepper Motor Driver Bi-Polar Stepper Motor Driver
This kit will drive a bi-polar stepper motor using externally supplied 5 volt levels for stepping and direction.
Photo: Unipolar Stepper Motor Driver Unipolar Stepper Motor Driver
Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC
Photo: Stepper Motor Controller Stepper Motor Controller
Preprinted Circuit Board with all the parts to assemble a controller that allows you to change directions, vary the speed, or single step the included stepper motor. Has LED's that flash when motor steps.
Photo: Stepper Motor Driver Stepper Motor Driver
Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC
Photo: Servo Motor Driver Servo Motor Driver
Using a PIC 16C71, a crystal, 8 resistors & 4 capacitors this kit will independently control up to 4 servo motors. We do not supply the potentiometers or servo motors. (We used a Futaba FP-S148 for out tests.) 5V DC power supply required. Full instruction