Motor: Sat Control

Using a PIC 16C71, a crystal, 8 resistors & 4 capacitors this kit will independently control up to 4 servo motors. We do not supply the potentiometers or servo motors. (We used a Futaba FP-S148 for out tests.) 5V DC power supply required. Full instruction

Preprinted Circuit Board with all the parts to assemble a controller that allows you to change directions, vary the speed, or single step the included stepper motor. Has LED's that flash when motor steps.

Vary the speed of your DC motor with this inexpensive circuit. Gear boxes can be costly and series resistors may cause stalling. This circuit delivers the voltage to the motor with pulses and the speed is controlled via pulse width modulation (PWM). The s

This kit uses a Grey switch aka bit switch, to single step a unipolar stepper motor in either direction. Uses a

Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC

This is a RC car project is the transmitter and receiver modules for a Remote Control car, with speed control and continuous steering.

Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC

This kit will drive a bi-polar stepper motor using externally supplied 5 volt levels for stepping and direction.

This kit allows you to control the speed of an AC motor. It can provide high torque at even low speeds.

Power on/off almost anything with this infrared controlled electronic switch. Some spell it Infared!

4 Channel RF Remote Control Relay Board with Auto Roll

4 Channel RF Remote Control Relay Board with Auto Roll

This stereo pre-amplifier will allow you to get extra control over your audio.

4 Channel RF Remote Control Relay Board with Auto Roll

Datasheet and PDF Data sheet for the TL494 Pulse Width Modulation (PWM) Control Circuit.

Teaches the fundamentals of a basic robotic sensing and locomotion principles while testing motor skills. Includes 5 switch wires controller to grab, release, lift, lower, rotate wrist, and pivot sideways 120°. Transparent arm shows the state-of-the-ar

The TX300 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 300 Watts.

The TX50 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 50 Watts.

The TX150 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 150 Watts.

The TX5 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 5 Watts.

The TX25 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 25 Watts.