Motor: Bike Alarm
Preprinted Circuit Board with all the parts to assemble a controller that allows you to change directions, vary the speed, or single step the included stepper motor. Has LED's that flash when motor steps.
Vary the speed of your DC motor with this inexpensive circuit. Gear boxes can be costly and series resistors may cause stalling. This circuit delivers the voltage to the motor with pulses and the speed is controlled via pulse width modulation (PWM). The s
Using a PIC 16C71, a crystal, 8 resistors & 4 capacitors this kit will independently control up to 4 servo motors. We do not supply the potentiometers or servo motors. (We used a Futaba FP-S148 for out tests.) 5V DC power supply required. Full instruction
This kit uses a Grey switch aka bit switch, to single step a unipolar stepper motor in either direction. Uses a
Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC
This kit will drive a bi-polar stepper motor using externally supplied 5 volt levels for stepping and direction.
Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC
This circuit is an alarm for the home, car and a lot more. It employs a magnet and reed switch to trigger the circuit. An intergral piezo sounder produces the alarm sound (100dB). There is also a relay capable fo handling up to 10 amps that will switch wh
Easy to build sound effect generator kits, inludes several different sounds and tunes.
This kit allows you to control the speed of an AC motor. It can provide high torque at even low speeds.
A sensitive photo Darlington transistor is used with a CMOS nand gate. The circuit detects light and triggers a siren. You could add your own triac or relay and switch practically anything. The kit uses the MEL12 Darlington super alpha phototransistor, ty
The loudest peizo alarm you will find (108 to 11dB output @ 1 meter). The kit includes a resonant cavity mounting case which is molded plastic, 2" x 3-1/4" x 1-1/4", plus mounting ears. If you want to totally startle a burglar, this is the
This super sensor detector sounds an alarm if someone approaches the unit. Adds safety to your home or office. Learn the basics of motion detector technology. Uses pyroelectric infrared sensor.
1 Comment - in Sound Activated
An electronic circuit that uses a regular 2-inch speaker to detect for low frequency vibrations in the ground (such as those cause by a deer or human walking), and sounds an alarm.
Sometimes you need to detect water, right? Well this kit will allow you to do just that.
People that viewed this page also looked at:
- Bi-polar Stepper Motor Drivers
- DC Motor Driver Circuits
- 8051 Micro-controller Program Stepper Motor
- PIC16F84 - DC Motors
- Alarm Circuits and Electronic Alarms
- Security Car Alarm Circuits
- Bike Alarms & Bike Security
- Motor Controler
- Door Alarms and Security Electronics
- Alarm Circuits
- Steper Motor
- Stepper Motor Kits
- Motor Speed Control (Stepper, Servo Motor Controllers)
- Servo Motor
- Notes On Burglar Alarm
- Servo Motor Driver Circuit
- Motor Servo Control & Other Control Circuits
- Interface 8085 Stepper Motor
- Motion Detector Sound Alarm
- How To Make A Toy Alarm
- Fire Alarm
- Alarm And Security Circuit
- Linear Motor
- Dc Servo Motors
- Stepper Motors
- 12 Volt Motor
- Doorknob Alarm
- Alarm Code Grabber
- Alarm Bell System
- Water Alarm
- Motor Controller Ic
- Dc Motor
- Motor Sat Control
- Smoke Alarm
- About Steper Motor
- Small Toy Alarm
- Electronic Stepping Motor Circuits