Interface: 8085 Stepper Motor

This kit uses a Grey switch aka bit switch, to single step a unipolar stepper motor in either direction. Uses a

This kit will drive a bi-polar stepper motor using externally supplied 5 volt levels for stepping and direction.

Preprinted Circuit Board with all the parts to assemble a controller that allows you to change directions, vary the speed, or single step the included stepper motor. Has LED's that flash when motor steps.

Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC

Drives any 5, 6 or 8 lead unipolar stepper motor. Based on the UCN5804 IC. All features of this IC

Vary the speed of your DC motor with this inexpensive circuit. Gear boxes can be costly and series resistors may cause stalling. This circuit delivers the voltage to the motor with pulses and the speed is controlled via pulse width modulation (PWM). The s

Using a PIC 16C71, a crystal, 8 resistors & 4 capacitors this kit will independently control up to 4 servo motors. We do not supply the potentiometers or servo motors. (We used a Futaba FP-S148 for out tests.) 5V DC power supply required. Full instruction

Teaches the fundamentals of a basic robotic sensing and locomotion principles while testing motor skills. Includes 5 switch wires controller to grab, release, lift, lower, rotate wrist, and pivot sideways 120°. Transparent arm shows the state-of-the-ar

Teaches the fundamentals of a basic robotic sensing and locomotion principles while testing motor skills. Includes 5 switch wires controller to grab, release, lift, lower, rotate wrist, and pivot sideways 120°. Transparent arm shows the state-of-the-ar

This kit allows you to control the speed of an AC motor. It can provide high torque at even low speeds.

Features a telephone ring generators, phone line in-use indicators and an audio interface circuit.

Allows for connection to Personal Computers USB (Universal Serial Bus)