Dc: Voltage Dropping Circiuit

A very simple variable power supply with a DC output voltage adjustable from 1-3- Volts, with a maximum DC current of 5 Amps. Uses LM338 DC voltage regulator IC.

Data sheet for the 7805 (LM7805), a compact IC 5v DC voltage regulator integrated circuit. This page further describes the 7805 and provides Datasheets for the IC device.

Variable-voltage DC power supply circuit. The output DC voltage is adjustable from 0.7-24V, with current limiting range from 50mA up to 2 Amps. Main transistor is the 2N3055.

An extremely simple and cheap DC power supply with variable voltage (1.2-25 Volts) control. The circuit uses an LM317 integrated voltage regulator Ic.

Build this educational Deluxe Bench DC Power Supply Kit

Provides 3 amps current at 3-30 Volts DC. Reduces ripple voltage to almost non-existant.

Vary the speed of your DC motor with this inexpensive circuit. Gear boxes can be costly and series resistors may cause stalling. This circuit delivers the voltage to the motor with pulses and the speed is controlled via pulse width modulation (PWM). The s

Build this educational Deluxe Bench DC Power Supply Kit

A very basic power supply that can be adjusted over a range of about 1.5 to 35 volts DC. If you add a heat sink (included), you can run it as hot as 2 Amps output; otherwise about 60 mA @ 12 volts. This is a text book circuit using an LM317, which is a 3

A very basic power supply that can be adjusted over a range of about 1.5 to 35 volts DC. If you add a heat sink (included), you can run it as hot as 2 Amps output; otherwise about 60 mA @ 12 volts. This is a text book circuit using an LM317, which is a 3

This is a practical battery eliminator for your projects. This is a basic power supply using two 7805 regulators; input up to 20 VAC from a transformer. There are two outputs; one regulated at 5 VDC, and the other one is variable. Includes plastic case. T

A low power consumption circuit that uses few components in order to power a 6 inch fluorescent tube (AC) from 12 Volts DC.

Compact positive (K124) and negative (K125) adjustable power supply +/-

Using a PIC 16C71, a crystal, 8 resistors & 4 capacitors this kit will independently control up to 4 servo motors. We do not supply the potentiometers or servo motors. (We used a Futaba FP-S148 for out tests.) 5V DC power supply required. Full instruction

This LCD panel meter is a very flexible design that can be customized to your own VOLT meter or AMP meter needs. It may be customized to measure any voltage range, standard or not. Or you can customize it to measure input from a transducer; full details a

A bright, variable flash rate strobe light. This is a 9 Volt battery powered xenon tube flasher. A small circut is easily transported for camping etc. Flash rate may be varied between 1 and 4 flashes per second.

Introduces the Optocoupler-triac MOC3010. Complete electrical isolation between input audio signal (low voltage circuit) and output light modulation. Operates from 100 VAC line. Audio input via 3.5mm jack.