Dc: Controller

A very simple variable power supply with a DC output voltage adjustable from 1-3- Volts, with a maximum DC current of 5 Amps. Uses LM338 DC voltage regulator IC.

Variable-voltage DC power supply circuit. The output DC voltage is adjustable from 0.7-24V, with current limiting range from 50mA up to 2 Amps. Main transistor is the 2N3055.

Vary the speed of your DC motor with this inexpensive circuit. Gear boxes can be costly and series resistors may cause stalling. This circuit delivers the voltage to the motor with pulses and the speed is controlled via pulse width modulation (PWM). The s

Using a PIC 16C71, a crystal, 8 resistors & 4 capacitors this kit will independently control up to 4 servo motors. We do not supply the potentiometers or servo motors. (We used a Futaba FP-S148 for out tests.) 5V DC power supply required. Full instruction

An extremely simple and cheap DC power supply with variable voltage (1.2-25 Volts) control. The circuit uses an LM317 integrated voltage regulator Ic.

Build this educational Deluxe Bench DC Power Supply Kit

Data sheet for the 7805 (LM7805), a compact IC 5v DC voltage regulator integrated circuit. This page further describes the 7805 and provides Datasheets for the IC device.

Provides 3 amps current at 3-30 Volts DC. Reduces ripple voltage to almost non-existant.

Preprinted Circuit Board with all the parts to assemble a controller that allows you to change directions, vary the speed, or single step the included stepper motor. Has LED's that flash when motor steps.

A very basic power supply that can be adjusted over a range of about 1.5 to 35 volts DC. If you add a heat sink (included), you can run it as hot as 2 Amps output; otherwise about 60 mA @ 12 volts. This is a text book circuit using an LM317, which is a 3

Build this educational Deluxe Bench DC Power Supply Kit

This kit uses a Grey switch aka bit switch, to single step a unipolar stepper motor in either direction. Uses a

This kit allows you to control the speed of an AC motor. It can provide high torque at even low speeds.

Use an old PC as a dedicated controller to turn on or off devices lab or radio shack. The circuit includes eight relays controlled with (included) software for either DOS or Windows 3.1. The kit is a boon to the Science Fair project, laboratory experiment

A very basic power supply that can be adjusted over a range of about 1.5 to 35 volts DC. If you add a heat sink (included), you can run it as hot as 2 Amps output; otherwise about 60 mA @ 12 volts. This is a text book circuit using an LM317, which is a 3

This LCD panel meter is a very flexible design that can be customized to your own VOLT meter or AMP meter needs. It may be customized to measure any voltage range, standard or not. Or you can customize it to measure input from a transducer; full details a

This circuit will allow you to control the level of a liquid. It switches a relay once the desired level is met.