Computers: IR Infrared Remote Controls and IR Controllers

Low cost 12 channel Infrared Remote Control with relay board

Power on/off almost anything with this infrared controlled electronic switch. Some spell it Infared!

4 Channel RF Remote Control Relay Board with Auto Roll

4 Channel RF Remote Control Relay Board with Auto Roll

This is a RC car project is the transmitter and receiver modules for a Remote Control car, with speed control and continuous steering.

4 Channel RF Remote Control Relay Board with Auto Roll

RoboSapien is an advanced robot that can perform many different movements with the push of a remote control button.

This kit uses an infrared beam to monitor door & passage-ways or any other area.

This stereo pre-amplifier will allow you to get extra control over your audio.

Datasheet and PDF Data sheet for the TL494 Pulse Width Modulation (PWM) Control Circuit.

The TX300 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 300 Watts.

The TX25 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 25 Watts.

The TX150 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 150 Watts.

The TX5 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 5 Watts.

The TX50 from Broadcast Warehouse is an extremely high quality stereo FM transmitter that complies with FCC Standards, meaning that it can be used for commerical broadcasting. Output power is 50 Watts.

Using a PIC 16C71, a crystal, 8 resistors & 4 capacitors this kit will independently control up to 4 servo motors. We do not supply the potentiometers or servo motors. (We used a Futaba FP-S148 for out tests.) 5V DC power supply required. Full instruction

This simple stereo audio amplifier will amplify audio for your low-medium impedance headphones and give you left/right balance control

Circuit diagram for an ultra low-noise driver/supply circuit for white LEDs, using the IC LTC3201. Ensures a stable brightness in white LED driven items.